Model tp-link_archer_c20_ac750_v1
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded openwrt-18.06.2-ramips-mt7620-tplink_c20-v1-squashfs-factory.bin file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
Comments
WLAN
3x3 MIMO, 2 x 2.4GHz Antennas, 1 x 5GHz Antenna
| TP-Link Archer C20 AC750 v1 | |
|---|---|
|
|
| Latest release | 18.06.2 Discontinued |
| Device Type | WiFi Router |
| Vendor | TP-Link |
| Model | Archer C20 AC750 |
| Flash | 8 MB |
| RAM | 64 MB |
| CPU | MediaTek MT7620A (ramips) 1 x 580MHz |
| Ethernet ports | 0 x GBit — 5 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n 5Ghz: a/n/ac |
| USB | 1x 2.0 |
| Switch | MediaTek MT7620A |
| Bootloader | U-Boot |
| Power Supply | 12 VDC, 1.0 A |
| Serial | check_circle |
| Additional resources | |