Model tp-link_archer_c20_ac750_v4
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded openwrt-18.06.2-ramips-mt76x8-tplink_c20-v4-squashfs-tftp-recovery.bin file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
Comments
WLAN
3x3 MIMO, 2 x 2.4GHz Antennas, 1 x 5GHz Antenna
TP-Link Archer C20 AC750 v4 | |
---|---|
Latest release | 18.06.2 Discontinued |
Device Type | WiFi Router |
Vendor | TP-Link |
Model | Archer C20 AC750 |
Flash | 8 MB |
RAM | 64 MB |
CPU | MediaTek MT7628AN (ramips) 1 x 580MHz |
Ethernet ports | 0 x GBit — 5 x 100Mbit |
WiFi |
2.4Ghz: b/g/n 5Ghz: a/n/ac |
Switch | MediaTek MT7628AN |
Bootloader | U-Boot |
Power Supply | 9 VDC, 0.6 A |
Serial | check_circle |
Additional resources |