Model tp-link_archer_c9_v1
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded openwrt-18.06.2-bcm53xx-tplink-archer-c9-v1-squashfs.bin file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
Comments
WLAN
3x3 MIMO
Recovery
TFTP-Recoveryname: ArcherC9v1_tp_recovery.bin
| TP-Link Archer C9 v1 | |
|---|---|
| Latest release | 18.06.2 Discontinued |
| Device Type | WiFi Router |
| Vendor | TP-Link |
| Model | Archer C9 |
| Flash | 16 MB |
| RAM | 128 MB |
| CPU | Broadcom BCM4709 (bcm53xx) 2 x 1000MHz |
| Ethernet ports | 5 x GBit — 0 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n 5Ghz: a/n/ac |
| Switch | Broadcom BCM4709 |
| Bootloader | CFE |
| Power Supply | 12 VDC, 3.3 A |
| Serial | check_circle |
| Additional resources | |