Model tp-link_archer_vr900v_1-0
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded ** file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
Comments
General
Note: This device basically features two entirely different SoCs: a 400MHz dualcore MIPS SoC and a 1GHz dualcore ARM Cortex A9
| TP-Link Archer VR900v v1.0 | |
|---|---|
| Latest release | Unknown Discontinued |
| Device Type | WiFi Router |
| Vendor | TP-Link |
| Model | Archer VR900v |
| Flash | 0 MB warning |
| RAM | 128 MB |
| CPU | Broadcom BCM63168, Broadcom BCM4709 (brcm63xx) 2 x 1000MHz |
| Ethernet ports | 4 x GBit — 0 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n 5Ghz: a/n/ac |
| Bootloader | CFE |
| Power Supply | 12 VDC, 3.3 A |
| Serial | check_circle |
| Additional resources | |