Model tp-link_cpe220_v1
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded openwrt-18.06.2-ar71xx-generic-cpe210-220-v1-squashfs-factory.bin file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
| TP-Link CPE220 v1 | |
|---|---|
| Latest release | 18.06.2 Discontinued |
| Device Type | WiFi AP |
| Vendor | TP-Link |
| Model | CPE220 |
| Flash | 8 MB |
| RAM | 64 MB |
| CPU | Qualcomm Atheros QCA95xx (ar71xx) 1 x 560MHz |
| Ethernet ports | 0 x GBit — 2 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n |
| Bootloader | U-Boot |
| Power Supply | 16-27 VDC passive PoE |
| Serial | cacel |
| Additional resources | |