Model tp-link_tl-wr710n_v2-0
Installation
Flashing via webinterface
- Download the factory firmware image offered above to your Computer.
- Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded lede-17.01.5-ar71xx-generic-tl-wr710n-v2-squashfs-factory.bin file. Click Upgrade.
- If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
- Connect to 192.168.1.1 with your web browser
- Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!
Comments
General
wallwart size; built in AC PSU
| TP-Link TL-WR710N v2.0 (EU) | |
|---|---|
| Latest release | 17.01.5 Discontinued |
| Device Type | WiFi Router |
| Vendor | TP-Link |
| Model | TL-WR710N |
| Flash | 4 MB warning |
| RAM | 32 MB |
| CPU | Atheros AR9331 (ar71xx) 1 x 400MHz |
| Ethernet ports | 0 x GBit — 2 x 100Mbit |
| WiFi |
2.4Ghz: b/g/n |
| USB | 1x 2.0 |
| Switch | Yes, serving LAN port only (eth1) |
| Bootloader | U-Boot |
| Power Supply | 100-240 VAC, 50/60 Hz, 0.3 A |
| Serial | check_circle |
| Additional resources | |