Model tp-link_tl-wr841n_v9

Installation

Flashing via webinterface

  • Download the factory firmware image offered above to your Computer.
  • Connect your Computer to a LAN port of the TP-link. If the configuration was not changed, the DHCP on the router will give you a 192.168.0.X address and the TP-link web administration page is 192.168.0.1. (User: admin, Password: admin) Under System Tools select Firmware Upgrade. Browse to the previously downloaded openwrt-18.06.2-ar71xx-tiny-tl-wr841-v9-squashfs-factory.bin file. Click Upgrade.
  • If the Webinterface tells you You have no authority to access this router! that’s because your browser does not send the correct HTTP referer header. Disable addons or use a different browser.
  • Connect to 192.168.1.1 with your web browser
  • Set your password and configure the router through the web UI. Basic Config Congratulations! You just installed OpenWrt on your Router!

Comments

WLAN

MIMO 2x2

Recovery

For TFTP, rename -factory image to wr841nv9_tp_recovery.bin

Installation

For TFTP, rename -factory image to wr841nv9_tp_recovery.bin

TP-Link TL-WR841N(D) v9
Latest release 18.06.2 Discontinued
Device Type WiFi Router
Vendor TP-Link
Model TL-WR841N(D)
Flash 4 MB warning
RAM 32 MB
CPU Qualcomm Atheros QCA9533-AL3A (ar71xx-ath79)
1 x 550MHz
Ethernet ports 0 x GBit — 5 x 100Mbit
WiFi

2.4Ghz: b/g/n

Switch Qualcomm Atheros QCA9533-AL3A
Bootloader U-Boot
Power Supply 9 VDC, 0.6 A
Serial cacel
Additional resources